Glock 17L Project
 

Yesterday I picked up the frame. As you can see you can never start any project no matter how big or small without the proper nourishment.

The frame is a new G17 Gen 3 frame. Not a fan of the Gen 4 frame, just a personal preference but there she is. As you can see I did install the magazine release, nothing earth shattering there by any means.

I will update the project as it goes along. I have a ton of parts on order and yet to order so this will take some time. The next parts in will be springs, pins and things like that. I have the Slide on Back Order with Lone Wolf so won't do much until that arrives. Then just the smalls and the barrel. I am going to do this in stages, frame first, slide second, then barrel and fine tuning stuff. FYI the completed Glock is 35 parts. My goal is to be completed by April 15th. (tax day is a big deal at my house)

I know we have some Glock haters in house but I hope you enjoy the process anyways. If nothing else I hope you can get a laugh out of it at some point and some good ribbing in.

Anyways here is the beginning!

Forge on good sir!

Lone Wolf upper? Longslide?......should be accurate as hell.....nice

Looks like a fun project

Looks like you got the parts mixed up. I've got a 17.http://www.cotep.org/forum/attachmen...2&d=1453828762

Thanks!

yeah, they make good stuff, I like them. The CS dept is top notch too!!

:rock::rock:

huh?

Good luck with it.

looks like it's going to be a fun build! don't tell anyone but I would probably shoot it.:eek::D

Your grip making, holster making, knife making skills DO NOT able you to touch said evilness. Please go to the corner and think about your sins.

:( well I did say probably.:rolleyes: