OK. The RPR customizations are done! See the following Pics.
Here's the forward view:
And the rearward view:
A close up of the scope mount (to show the very small clearance of the objective lens, even with the "high mount" rings):
And another scope mount view
The scope is only mounted temporarily. I realize it's not even. It's not torqued down yet. I still have to mount the bubble level on it. This was just to determine the appropriate eye relief. After I mount the bubble level (forward of the turrets), then I'll align it properly and torque it to spec (18 in/lbs).
But here it is! I await my safety class at JTAC.