COTEP.org  

Go Back   COTEP.org > Main Category > Pulling The Trigger > Range Reports

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 03-02-2014, 03:30 PM
KeystoneWeaponBK's Avatar
KeystoneWeaponBK KeystoneWeaponBK is offline
COTEP Member
 
Join Date: Dec 2012
Location: Bloomsburg PA Area
Posts: 146
Thanks: 9
Thanked 39 Times in 9 Posts
Default Range report RIA9

So despite it being like 20 degrees outside I went to the range to function check my 9mm franken-pistol that I have been working on for this shooting season... I have been tuning, stoning, shooting, tuning, repeat, repeat, repeat... To try and get everything perfect...

It ran well with the exception of I needed to take out a few drags (I had dykem layout fluid on every internal so I could inspect it afterward for burrs and stuff) and I need to dial down the recoil spring by about 2 pounds and reshape my firing pin stop... So I did that last night and hopefully can get out to retest it this week.

It is a 9MM single stack that I have two loaded slides for so I can quickly change between 9mm and 38 Super and not have to mess with sights and stuff.

I am very pleased with it's test yesterday, here's some pix:
Reply With Quote
The Following 3 Users Say Thank You to KeystoneWeaponBK For This Useful Post:
Caleb (03-02-2014), Lonestar grips. (03-02-2014), skosh69 (03-02-2014)
 




All times are GMT -4. The time now is 01:50 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.