|
Register | Forums | Blogs | Today's Posts | Search | Donate |
#11
|
|||||
|
|||||
Well the stock came in, and I did the install... So painless. And yet soothing.
|
#12
|
|||||
|
|||||
Looks great.
__________________
There are no dangerous weapons; there are only dangerous men. To speak without thinking is to shoot without aiming. |
#14
|
|||||
|
|||||
Looks only count for beauty queens! I want bullet holes in paper!
It does look good though!
__________________
CBOB0746 NRA Life Member Florida CWL Since 1992 |
#15
|
|||||
|
|||||
Quote:
This!!!!!!!
__________________
**I have been Enlightened** |
#16
|
|||||
|
|||||
I did a little cleaning on the bolt yesterday, there was some rust and wear..
Last edited by Pirate; 09-03-2017 at 01:05 PM. |
#17
|
|||||
|
|||||
Nice work, looks good!
__________________
**I have been Enlightened** |
#18
|
|||||
|
|||||
Looks like it cleaned up pretty good.
Make sure you measure your firing pin protrusion. On that looking tool in the cleaning kit, there will be 2 notches, one marked 75, and the other marked 95. The foring pin should be between the two lengths. If you naad to adjust it, the screw on the back of the bolt.
__________________
There are no dangerous weapons; there are only dangerous men. To speak without thinking is to shoot without aiming. |