COTEP.org  

Go Back   COTEP.org > Main Category > The Dremel Room

Reply
 
Thread Tools Display Modes
  #551  
Old 06-20-2022, 10:51 PM
Caleb's Avatar
Caleb Caleb is offline
COTEP Member
 
Join Date: Sep 2013
Location: Earth
Posts: 11,455
Thanks: 4,190
Thanked 1,137 Times in 254 Posts
Default

Well good luck bro, hope it works out in your favor.


Sent from my iPhone using Tapatalk
__________________
**I have been Enlightened**
Reply With Quote
  #552  
Old 06-21-2022, 10:16 AM
FfNJGTFO's Avatar
FfNJGTFO FfNJGTFO is offline
COTEP Member
 
Join Date: May 2016
Location: Wesley Chapel, FL
Posts: 1,629
Thanks: 1,501
Thanked 206 Times in 71 Posts
Default

Quote:
Originally Posted by Caleb View Post
Well good luck bro, hope it works out in your favor.


Sent from my iPhone using Tapatalk

Much appreciated. I'm currently reviewing options in re: whatever these clowns in DC want to do in re: 2A and what I want to "early panic buy" before it turns into true "panic buying."



I just scored 1000 rounds of PMC M855, yesterday, combined with the amount of American Eagle I had previously. I'm thinking of beefing up my .45ACP a little. I'm comfortable with my 9mm inventory at present but I might want a little more JHP.



As far as the "gear" goes, I might be looking at a SIG-Sauer P322 (the .22LR) which has a 20 rnd mag I believe. Might be good for teaching my "youngins" initially (although my niece is a crack shot on my 1911 .45ACP). And, for that, I could probably use a little more .22LR, although I'm anticipating that won't be hard to find. M855 Green tip might be. I'm also looking at a SW M & P Shield Plus, just to compare it to my Shield 1.0. Finally, I may also stock up a bit on my .308 win for my PRS.



The big question for me is, do I want to invest at this point in any more AR Lowers and parts kits, in the event that the ATF decides to get "jiggy" with them. And, do they have enough mojo to make those kinds of restrictions? Not sure. I still have the one serialized lower for my 2nd build and all the parts for that. As soon as I get the roof and the HVAC done, I'll get back to that.
Reply With Quote
  #553  
Old 06-21-2022, 08:11 PM
Caleb's Avatar
Caleb Caleb is offline
COTEP Member
 
Join Date: Sep 2013
Location: Earth
Posts: 11,455
Thanks: 4,190
Thanked 1,137 Times in 254 Posts
Default

Maybe get one or two more if you plan on continuing to build them up even if the “ban” goes into effect.


Sent from my iPhone using Tapatalk
__________________
**I have been Enlightened**
Reply With Quote
  #554  
Old 06-25-2022, 07:04 PM
FfNJGTFO's Avatar
FfNJGTFO FfNJGTFO is offline
COTEP Member
 
Join Date: May 2016
Location: Wesley Chapel, FL
Posts: 1,629
Thanks: 1,501
Thanked 206 Times in 71 Posts
Default

Quote:
Originally Posted by FfNJGTFO View Post
Well, in light of the potential to close off Lake City's production of 5.56 Green Tip, I just scored another 1000 rounds at .50/round. I did see it at .47 per round but those were out of stock.



I'll keep you posted on the Point Finance deal, but it does seem to be moving forward. We'll see. Cautiously optimistic.

Shipment arrived today in Good condition. I'm up 1000 rounds.

And the point deal is still moving along at this point. I got some good news from the appraiser. I just have to see how much they discount it.


Keep you posted.
Reply With Quote
  #555  
Old 06-25-2022, 10:59 PM
Caleb's Avatar
Caleb Caleb is offline
COTEP Member
 
Join Date: Sep 2013
Location: Earth
Posts: 11,455
Thanks: 4,190
Thanked 1,137 Times in 254 Posts
Default Building Confidence

Awesome news.


Sent from my iPhone using Tapatalk
__________________
**I have been Enlightened**
Reply With Quote
  #556  
Old 06-29-2022, 09:54 AM
FfNJGTFO's Avatar
FfNJGTFO FfNJGTFO is offline
COTEP Member
 
Join Date: May 2016
Location: Wesley Chapel, FL
Posts: 1,629
Thanks: 1,501
Thanked 206 Times in 71 Posts
Default

Quote:
Originally Posted by Caleb View Post
Maybe get one or two more if you plan on continuing to build them up even if the “ban” goes into effect.


Sent from my iPhone using Tapatalk

I might consider that. As is often said, "better to have them and not need them than to need them and not have them."
Reply With Quote
  #557  
Old 07-08-2022, 03:47 PM
FfNJGTFO's Avatar
FfNJGTFO FfNJGTFO is offline
COTEP Member
 
Join Date: May 2016
Location: Wesley Chapel, FL
Posts: 1,629
Thanks: 1,501
Thanked 206 Times in 71 Posts
Default

Quote:
Originally Posted by FfNJGTFO View Post
No, none for paying off early. Just the standard costs for the re-appraisal and other "buy-out" doc fees (very nominal).





I actually miscalculated that. The percentage is not based on the 2nd appraisal value, but on the delta between the two appraisals.



Example: Initial appraisal is $300,000 like before. They adjust it by 15% to cover their "depreciation margin." Thus, we start at $261,000.00.


The percentage of "their share" is based in part on the amount I draw, initially. I can draw a total of $59,000.00. I did bump it up from $30,000 to $40,000. As a result, the percentage is now 43.2% of the delta between the adjusted initial value ($261,000) in this case, and the resultant appraisal (at the time I buy them out). Say that's $315,000.00 Their "share" would then be ($315,000 - $261,000) * .432 = $23,328.00 + the principal I drew. If it depreciates below $261,000 in the time the contract is active, then I would owe less "principal" money. I don't even think that will happen because if they can project that, they would not accept the loan, initially.



At one point I was considering going up to $50,000.00 in principal, but they told me the percentage would be over 50% in that case. I told them to keep it at $40,000.00.



So, given the above numbers, and if I put away, say, $800.00 a month in a savings account for 8-10 years, I should be able to buy them out completely and get all my equity back. Even if their share comes to $60K to my $40K principal. That's $100K total. I should be able to cover that within 8-10 years.


We'll see. They might still deny me if they think it's not worth the investment. We'll see.

Update: It looks like the Point Financing deal will proceed. The closing has been scheduled for later this month, and I should have the funds by 08/02 or thereabouts. I can get my roof done, my HVAC redone and some other things. Maybe a little room for some more "inventory" and ammo. They gave me a break on their share % as well only 34.2% to take out $45K.





Thanks all! Keep ya posted!
Reply With Quote
  #558  
Old 07-10-2022, 09:53 AM
Caleb's Avatar
Caleb Caleb is offline
COTEP Member
 
Join Date: Sep 2013
Location: Earth
Posts: 11,455
Thanks: 4,190
Thanked 1,137 Times in 254 Posts
Default

Hope it all works out for you bud.


Sent from my iPhone using Tapatalk
__________________
**I have been Enlightened**
Reply With Quote
  #559  
Old 07-27-2022, 08:52 AM
FfNJGTFO's Avatar
FfNJGTFO FfNJGTFO is offline
COTEP Member
 
Join Date: May 2016
Location: Wesley Chapel, FL
Posts: 1,629
Thanks: 1,501
Thanked 206 Times in 71 Posts
Default

Quote:
Originally Posted by Caleb View Post
Hope it all works out for you bud.


Sent from my iPhone using Tapatalk

Well, wish me more luck, then. Today is "closing" day on the HEI. The mobile Notary arrives at 10a, this morning. After which there is a 3 day rescission period. After that, the funds are supposed to arrive in my checking acct via wire transfer.



We'll see.
Reply With Quote
  #560  
Old 07-29-2022, 08:13 PM
Caleb's Avatar
Caleb Caleb is offline
COTEP Member
 
Join Date: Sep 2013
Location: Earth
Posts: 11,455
Thanks: 4,190
Thanked 1,137 Times in 254 Posts
Default

Quote:
Originally Posted by FfNJGTFO View Post
Well, wish me more luck, then. Today is "closing" day on the HEI. The mobile Notary arrives at 10a, this morning. After which there is a 3 day rescission period. After that, the funds are supposed to arrive in my checking acct via wire transfer.



We'll see.

No luck but, I can send knee mail.


Sent from my iPhone using Tapatalk
__________________
**I have been Enlightened**
Reply With Quote
Reply




All times are GMT -4. The time now is 01:47 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.