S&W 986 9mm

[girphoto]

So Hello to all

What Have I been doing...well except for a heavy work load during the mid term elections and getting ready for next years Steel Challenge Nationals and in the Cowboy world, the Florida State siege, the Gold Coast two day and the Ides of March two day and loading about 2K -6K of ammo a week .....Not Much


The attached is my new wheel gun for the revolver section of the Nationals.

It started off as a new S&W 986 / 9mm 7 shot.

after about two week of inside work, it now has an Apex competition hammer, Apex extended firing pin, recut sear, rear sights from LPA (installed but on the next updated photo).
It has a HiViz .310 hight F.O. Green front.
Grips were made for me by Hogue and the extended cylinder release by Hogue.

It uses moon clips made by TX Industries.

Trigger pull is at 6.5#'s DA (only) and I use loads that are 9mm, Federal primer, 231 powder with 3.5 g.







I will be on from time to time...any questions on the gun just let me know.