Race revolver
 

Howdy Pard's

As most of you know, I not only compete in Cowboy shooting but also in Steel Challenge.
And
As most of you know, I can not leave a gun Stock and must play with it and make it a little special.

So, since I have been shooting in the hot heat of the Florida Summer, I have decided to take a perfectly good gun out of the safe and try to make it even better. Well, I think that I have done sooooooooooo.

I started with a S&W model 67-5 (a performance center gun) and removed the rear sights, and the cylinder.
The cylinder was sent to TK Industries and had it cut for Moon-Clips (hold six rounds and do fast reloads)
I replaced the rear sight with a custom rail and attached a Red-Dot sight.
The black Fat rubber grips were removed and replaced with a set of Jerry Miculek thin grips.
The springs (hammer and trigger) were replaced with a set for speed competition.
The last thing replaced was the cylinder release and it was replaced with an extended quick release one.


The result is as follows:

http://i984.photobucket.com/albums/a...oto/67-5-1.jpg

http://i984.photobucket.com/albums/a...oto/67-5-2.jpg

http://i984.photobucket.com/albums/a...oto/67-5-3.jpg


Enjoy!

GaryR

Very nice. Where do you compete in Cowboy shooting?

Sweet!

Great project Gary. Thanks for sharing!

Howdy

I belong to two clubs in Florida

One that shoots at Markam Park (The Goldcoast Gunslingers)
and my primary Club
The Okeechobee Marshals that shoots in Okeechobee

We also shoot in Malabar once a month...We shoot about 4 times a month and travel to Various State matches and regional matches

GaryR

Really nice Gary ,okay so I need to find a used SW revolver in 45 cap.....


Clyde

I took an NRA class with a woman who shot with the club at Markham. I actually boy live about three miles from there. Wouldn't mi d watching once.

Very nice...Like the grips...JM is a stud!

Sweet!

Nice project results.