Quote:
Originally Posted by brownie
I spoke with the gunsmith about listing who he was, he's in Fla and on this site.
RickMcC, might want to check with him on makers of parts and works he's doing for me. He's also going to bevel the extractor for more positive feeding. Should be a race car inside and look like a mutt on the outside.
|
Upgrades to the pistol will include:
Harrison Custom Retro Extreme Service (HC ES) Ignition Set (hammer, sear and disco)
HC ES hammer strut and strut pin
HC ES short trigger
Colt LW sear spring; set to 4 1/4 - 4 1/2 pound trigger pull
Wolff plunger spring
Stone trigger track in frame
Radius bottom of extractor, check/set tension
Polish series 80 levers and plunger as necessary
Check thumb safety/plunger interface geometry and recut/polish as necessary
Please note: No, I'm not in business, or looking for any work!