Quote:
Originally Posted by FfNJGTFO
That's the hard part, actually... ensuring you have all the holes aligned and that the roll pin goes through all 4 of them. I'm finding thst the most difficult part of that process,,, without, of course damaging the roll pin. I will try it with a roll pin holder and a small bit of lube and we'll see.
|
You can align the holes using a guide (for lack of a better word) and then tap the pin in a little at a time with a small hammer/mallet. Do you have a gunsmiths block? Those are handy to have around. I think a little gun oil can help but also might make it slippery to handle.
PS: Make sure the tube is oriented correctly before you pin it. The block sits lower than the upper receiver , therefor the tube steps down into the block from the receiver.
Sent from my iPhone using Tapatalk