Here's an initial review of a slim double magazine holder made by our own Eaglestroker. I used my 1 1/4" Milt Sparks gun belt, with each holder positioned at as close to 3:00 and 9:00 as my belt loops would allow. Both designs have gaps between the belt loops so they can actually straddle the pants loops. I used government sized Wilson and DW mags, fully loaded. I wore a fairly loose fitting t-shirt as a cover garment.
It is very well made, and works even better than it looks. I wore Eagle's on my weakside and a double holder by Milt Sparks on the strongside for 2 1/2 hours as an initial test.
Immediately, I noticed that Eagle's holder is designed to ride approximately 1 1/4" lower that the MS one. This higher loop position keeps the top of the magazines fully against my body, whereas the MS magazine tops sit away from my body. This difference is enough to allow the MS held mags to be easily seen, while the Eagle held mags were not visible at all.
Magazines fit very tightly in the holders initially. I'm certain that with some minor stretching, they will end up holding the magazines with the same tightness as the MS ones do now (the MS ones were also very tight initially).
Eaglestroker's holder was completely comfortable for the two and half hours or so I wore it today, and I'm certain that it would feel exactly the same after another 12 hours.
On the appearance front, the MS product is slightly superior with straighter edges and a glossier finish, but these details affect performance in no way (and MS wants over twice the $$ for theirs).
Overall, I'm very satisfied with the mag holder, and can't wait for the snap loop holder to arrive.
Here are a few photos.
