My example is machined very nicely and exhibits no burrs. The bevels on the slide are cut nice-n-even on mine and all the parts fit each other very well. The barrel feet are making proper contact on the bowtie. There is minor play in the barrel bushing at both the barrel and the slide, but it is by-far tighter than the 2 Colts I owned in the past and the RIA I currently own. The beavertail and back of the slide could both use some blending, but I dont consider them that bad for a factory pistol. The thumb safety does hang off the back of the frame a little when in the off position, but nothing a little blending couldnt remedy. The only thing I would say I dont care for on my example is that there is a gap between the rear sight and the top of the slide. Other than that, I will let the pictures speak for themselves.
beveled on the front
beveled on sides
serrated, skeletized trigger with adjustment screw (minor play vertically, almost undetectable horizontal play) & extended mag release that has nice purchase when pressing
MSH fitted very well, and plenty of meat to remove the checkering if someone prefers scallops to be added or something
beveled magwell
