[SemperFi1977m]

beavertail pushed in (needs some minor blending, but not a bad fit for factory IMHO)



back of slide could use some blending, but too much metal is better than not having any to blend

Here's a nice view of the cutouts on both sides of the beavertail

Heres the hammer that I didnt think I would like the looks of, but I must say it presents itself much better in person than it does in pics. The serrations on it are some of the best Ive felt for gaining a good purchase on when cocking


you can see here where the thumb safety hangs over the back of the frame underneath the tang, but that's an easy thing to correct