Thread: Race revolver
View Single Post
  #1  
Old 07-02-2014, 05:05 PM
girphoto's Avatar
girphoto girphoto is offline
Founding Member
COTEP Member
 
Join Date: Feb 2012
Location: South East Florida
Posts: 493
Thanks: 85
Thanked 146 Times in 40 Posts
Default Race revolver

Howdy Pard's

As most of you know, I not only compete in Cowboy shooting but also in Steel Challenge.
And
As most of you know, I can not leave a gun Stock and must play with it and make it a little special.

So, since I have been shooting in the hot heat of the Florida Summer, I have decided to take a perfectly good gun out of the safe and try to make it even better. Well, I think that I have done sooooooooooo.

I started with a S&W model 67-5 (a performance center gun) and removed the rear sights, and the cylinder.
The cylinder was sent to TK Industries and had it cut for Moon-Clips (hold six rounds and do fast reloads)
I replaced the rear sight with a custom rail and attached a Red-Dot sight.
The black Fat rubber grips were removed and replaced with a set of Jerry Miculek thin grips.
The springs (hammer and trigger) were replaced with a set for speed competition.
The last thing replaced was the cylinder release and it was replaced with an extended quick release one.


The result is as follows:








Enjoy!

__________________
NRA-LIFE,COTEP, USPSA,STEEL CHALLENGE,SASS,GSSF, ICORE
GLOCK Certified Armorer

Last edited by girphoto; 07-02-2014 at 05:08 PM.
Reply With Quote
The Following 2 Users Say Thank You to girphoto For This Useful Post:
NAMVET72 (07-02-2014), sdmc530 (07-02-2014)