Quote:
Originally Posted by Hoss in IL
I got ya Stijn.
Do y'all have lead bullet casters over there, like we do here, or are you relagated to shooting jacketed/fmj bullets? What bullets are you shooting?
I'm surprised Vihtavuori powder isn't readily available (maybe it is), it's made in Finland. If you could get it, I'll bet it would be expensive. It's crazy expensive here (my opinion).
Keep us updated on the goings on.
|
Leadcasting gear is available, haven't decided yet if i wanna cast lead bullets or not. For the time being i'll use HN 190 grain semi wadcutters. and see how that works out.. Got a box of 500 to keep me busy
Just buggered around some more with the Dillon, powder die set, seater and crimp die set.
Ran a bit of test cases.. no powder yet, as i don't have any scales to measure the load yet, that arrives tomorrow..
Left the primers out as well, as i don't want to risk having a powder less but finished looking shell laying around to get mixed up in the rest.. potentially causing an issue @ the range.
For all intent and purpose, these shells ran the merry go round, no jams, the assembly works.I cycled them through the 1911, no issues there either..
All i gotta do now, is
- Bolt the big sucker to my desk when i get the strongmount
- install the powder check sensor
- run the cases through the corncob tumbler
- look up what loads to use with the powder i have and the 195 grain bullets
- Run some test batches
I'm almost good to go.