anybody

Riverpigusmc · #1 11-29-2015, 09:23 PM

ever tumble primed brass? I'm in the process of breaking down some ammo from an unknown source, and the brass is tarnished. Thanks

Lonestar grips. · #2 11-29-2015, 10:06 PM

I tumbled a live round once by accident. it didn't go off but that may not always be the case. (no pun intended) if they're just primed cases then the worst that could happen is they go off and you lose the primers.

Rick McC. · #3 11-29-2015, 10:46 PM

I've actually read several posts by guys that tumble their brass again after they're fully loaded rounds.

I've never done that myself, but I'd think that cleaning primed brass in a vibratory tumbler would be much less hazardous than that.

In your situation, that's what I'd probably do. The only downside to it I see would be if the tumbling media plugged the flash hole in the brass.

I see it all the time in mine, but the pin that pushes the primer out gets rid of it as well.

In your instance of already primed brass; that won't be happening.

skosh69 · #4 11-29-2015, 11:55 PM

Have you given any thought as to how you're gonna re-size the brass without de-priming it?

It's actually pretty simple

Lonestar grips. · #5 11-30-2015, 01:32 AM

Quote:

Originally Posted by skosh69

Have you given any thought as to how you're gonna re-size the brass without de-priming it?

It's actually pretty simple

he wouldn't need to re-size it unless he fired it would he? of course he would need to bell the case mouth out. most of my dies do that and de-prime at the same time so he'd lose the primers that way.

if that's what your stuck with doing

get yourself a brick of Gulf wax, push the primed cases into it and go out in the backyard and shoot them with Jake. lots of fun.