|
|
| Register | Forums | Blogs | Search | Today's Posts | Mark Forums Read | Donate |
 |
 |
 |
|
#1
09-26-2011, 12:44 AM
|
|||
|
|||
Valor Durability??
So I ordered a Dan Wesson Valor. It is newer than the last one I saw. The Ejection port is lowered to .390 and the bevel next to the extractor leaves the metal real thin. Is there any worry about the slide cracking?
Probably a dumb question, but the one I had seen in the store a while back was probably only cut to .450 with a much higher bevel by the extractor. 
|
| Thread Tools | |
| Display Modes | |
Threaded Mode