|
|
| Register | Forums | Blogs | Today's Posts | Search | Donate |
 |
 |
 |
|
#10
10-26-2020, 03:40 PM
|
|||||
|
|||||
Update: Had a good conversation with Magpul this afternoon. In brief, he stated that the delta ring/barrel nut can have variations in the external diameter (at the teeth). They guarantee that if you use a "Colt" Milspec barrel nut or similar one, it will fit. The diameter from tooth to tooth can be between 1.55 - 1.56" but no more. He did state that while the internals may fit the upper, the teeth can be different. So, my mission now is to find the appropriate barrel nut and hope that it fits my current delta ring assembly. I won't mind replacing the entire assembly if needed.
He also stated that I could use a low profile gas block and the triangular HG cap with the M-LOK model of HG that I have. So we'll see what's up with that. OK, I'll be searching for that new barrel nut and will keep you posted. I'm also awaiting shipment of my replacement gas tube roll pins, so we'll see. I'll post pictures once I get the barrel nut issue resolved (or not). 
|
Threaded Mode