Reloading Basics for the Novice

[coatessey]

Originally Posted by AFJuvat

Awwww... and I was writing one up for the forum.....

Please post one. Those of us on the fence are always looking for additional resources and points of view.

[Riverpigusmc]

I use a Lee 4 hole turret press. I remove the ratchet so it does not auto advance, and load in batches. I prime off the press, so it's resize 50, then prime on a hand primer, then expand those, then load them with a Little Dandy powder measure, then seat and crimp in separate steps. Once my dies are set in a turret, I don't have to change them unless I go to a different bullet profile. Changing calibers is a snap....just snap the .45 turret out, snap a new turret in...dies are already set