Researching the LNL and 650

[NAMVET72]

Yes we know you have Big Bucks,

Unless you have lots of brass and money just get a single stage to start with, get two or three reloading manuals, read and read again. Then take it slow, do one at a time, measure every single load.....Good luck

[Gatorade]

I am still getting unpacked from vacation but one point I will make is that i have too much OCD to deprime and then load. I have seen some nasty junk in primer pockets and just jamming another primer in there before the pocket gets cleaned doesn't seem like a good practice. So I run the brass through the cleaner, deprive and resize. Then run it through the polish media. Then I can either bag it and pick up later or hand prime and flare. Charging and seating are pretty easy steps after that.