Reloading conversation with Mike

[sdmc530]

Originally Posted by DaFadda

I'm thinking the only thing dirty that you cannot get to is the primer area. Tumble the cases with the spent primer intact, then start the process? I think Gatorade checks and cleans each of his primer pockets. Perfect time to check for small primer pockets in 45. But I have a question... I believe you load primarily 45 acp. What happens when a small primer case slips through? Does it jam up the machine? just crushes the new primer? spills powder? Nothing? Serious question because I just don't know.

Michael

I do tumble with the old primer in, its too big of a pain to clean out primer pockets. Learned that the hard way. I tumble in media and a bit of NuFinish car wax in and tadaa clean brass.


Every once in a while I do get a small primer mixed in. When cycling the press It will size, deprime and bell the case just fine. But when you try to prime a small primer case it will just abruptly stop the process. So all you do is remove the case and keep going its really no big deal. its a show stopper but not really a big deal.

I plan on making a video soon, was going to this morning but water heater stopped being hot so new install is this morning.

[RKP]

GREAT thread Gents !!

[pitor]

Originally Posted by RKP

GREAT thread Gents !!

Agreed