How Phil reloads on a Dillon:

[sdmc530]

So here is the filling up of the press. If you watch to the end I put about 400 cases into the case feed and it jams up. I did it on purpose to show you that is does that. You can only put in maybe 250 at a time or it fails. I think this is a problem but Dillon says that is what its supposed to handle. Just my opinon that its not large enough:

Funny is that I had the radio on in the background and my music is copyrighted so its muted by Youtube. I wish I knew that, the primer tube has an alarm on it you can't hear when it gets low, it beeps. Some music plays on some vids and not in others. No making fun of my music from the 90's ether!


Loading up:



Here is when primers get low, beeps and I reload the primers, start the case feed and carry on:



Press working from the inside view:

[sdmc530]

here is what I did in 3 hours with all the loading of supplies and dealing with the camera. Also I failed to put the pin in primer tube so I loaded 100 primers in and then dumped them all on the floor. Camera should have been rolling cuz I was cussing pretty good!

I load 991 loads of 45 185 gr plated round nose with 5.5gr of 231. My favorite range load to use. I always put them in the case upside down because as you can see I always load one or two per 1000 with the primer in backwards, not sure how I even manage this AND I have fat fingers so easier to get out too.



I will do one more video and that will be how to change heads and to do a caliber conversion. I have some 10MM to load so will do that hopefully soon!