|
|
| Register | Forums | Blogs | Search | Today's Posts | Mark Forums Read | Donate |
 |
 |
 |
|
|
|
#1
06-07-2017, 11:36 AM
|
|||||
|
|||||
 Stripped the parts off another build and assembled them! The trigger pin holes are not as tight as my other factory lowers. Anti-roll pins will take care of that.  The rest of the assembly went great! Safety works, trigger works. Bolt catch works, mag release works all set!  The rear take down shelf was already milled out from Range Tool. I left it as is and it looks like it may be about 1/64" or 1/32" too tall. The rear takedown lug on one of my uppers wouldn't fit. I am going to try and smooth the insides out with a dremmel sander and that should also take the top off that rear shelf. One of my PSA uppers fit but I had to get a punch and force the rear pin out to remove it.  On the whole it is my first pretty much complete AR lower. It functions and is not pretty but looks like it will be functioning soon! Woo Hoo!
__________________
CBOB0746 NRA Life Member Florida CWL Since 1992 Last edited by Gatorade; 06-12-2017 at 01:34 PM. 
|
|
#3
06-07-2017, 12:42 PM
|
|||||
|
|||||
|
May I suggest to
 that this thread become a 'Sticky'. 
__________________
Rich COTEP #762 A gun is a tool, no better or no worse than any other tool: an axe, a shovel or anything. A gun is as good or as bad as the man using it. Remember that. And shepherds we shall be, for Thee, my Lord, for Thee. Power hath descended forth from Thy hand, that our feet may swiftly carry out Thy command. So we shall flow a river forth to Thee, and teeming with souls shall it ever be. In nomine Patris, et Filii, et Spiritus Sancti.
|
|
#4
06-07-2017, 02:04 PM
|
|||||
|
|||||
|
Quote:
__________________
CBOB0746 NRA Life Member Florida CWL Since 1992
|
|
#7
06-10-2017, 09:08 AM
|
|||||
|
|||||
|
May I suggest you use the top plate as a template rather than a guide? If you scribe a line on the 80, then remove the top plate you can use the line as your guide and save the plate from being chewed by the bit or end mill.
Randall
|
 |
| Thread Tools | |
| Display Modes | |
Hybrid Mode