COTEP.org  

Go Back   COTEP.org > Main Category > Pulling The Trigger > Range Reports

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #13  
Old 05-05-2011, 09:42 PM
titanse05's Avatar
titanse05 titanse05 is offline
Founding Member
COTEP Member
 
Join Date: Apr 2011
Location: Near Somerset, PA
Posts: 734
Thanks: 26
Thanked 31 Times in 7 Posts
Default

Well I got my slide back today and got it all back together and ready to rock. If the weather is decent tomorrow I will be out to run another 200 rounds thru it. However I did notice when I was putting it back together that there was a bit of peening on the frame where the guide rod is contacting the frame. The aluminum frame in this area is "turned up" the slightest bit at the edge. See the pics below.





Should this be an item for concern or will it flatten itself out as I continue to break it in? I was thinking that after another several hundred rounds that if the metal isn't flattened out that I'd break the dremel and sanding wheel out and smooth it out.
__________________
CBOB0235
Reply With Quote
 

Thread Tools
Display Modes



All times are GMT -4. The time now is 01:27 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.