|
|
| Register | Forums | Blogs | Search | Today's Posts | Mark Forums Read | Donate |
 |
 |
 |
|
|
|
#1
08-10-2012, 10:11 AM
|
|||||
|
|||||
You are correct, Padre. I used a local welder that does TIG welding, it cost me a 12 pack, and took him about 30 min. total. Much cheaper than taking to a GS who'll charge about 45-50 bucks for the same thing. If I had found this, a Battle Comp 2.0
 which is a muzzle brake/compensator, and I think looks cool I'd have had it welded on instead. http://battlecomp.com If you've already got a 16" then you could get the 1.0 and be just fine as a screw-on device. However, with the 14.5 I needed the 2.0 to make it in the caliber I needed (6.8 SPC).
__________________
Ron #CBOB0604 Proud Member: "Team Ranstad" Last edited by Roverron; 08-10-2012 at 10:26 AM. 
|
|
#2
08-10-2012, 05:40 PM
|
|||||
|
|||||
|
Following your expert advice - I contacted a local 'smith who will do all the metal bending and then Cerakote the barrel for me.
Glad you all talked me down from the ledge!
__________________
COTEP #447
|
|
#3
08-10-2012, 05:57 PM
|
|||||
|
|||||
|
Oh I'm not an expert but we do have lots of those on the forum. Glad it worked out for you. I had a great instructor, my older bro.
__________________
Ron #CBOB0604 Proud Member: "Team Ranstad"
|
 |
| Thread Tools | |
| Display Modes | |
Hybrid Mode