Project "Dirty Hands"

Caleb · #1 10-01-2013, 09:42 PM

Caleb · #2 10-01-2013, 09:43 PM

Caleb · #3 10-01-2013, 09:44 PM

Caleb · #4 10-01-2013, 10:07 PM

First impression..............not bad. The slide to frame fit is pretty tight with very little movement up and down, I'm sure it will loosen up a bit after it gets shot a bunch. The beaver tail fit is .....ok. MSH fit is tight with no wiggle but, as you can see in the pics.....the bottom has a big gap. Not worried about that because, that is something that will get changed later. The barrel bushing fits nice and snug although, I can still field strip with only my hands (no bushing tool needed). The sights are a nice three dot as seen on most EDC pistols. I will upgrade them to a target style later. The trigger...well, it sucks. The pull weight is averaging around 6lbs......ugh! The trigger also moves up and down as well as side to side quite a bit. That will be changed for sure. The magwll has no bevel in it so, the mags are a bit difficult to change fast (at least for me). The mag release is also a bit stiff and I have to really push on it to release the mags. Not sure if it just needs break in or the spring needs to be lightened. Over all, I am happy so far. The finish is excellent and looks "tactical". Has a flat look to it and was applied nicely. These pics do not do it justice. That's it for now.....dinner calls so, I gotta go. Will update once I get some rounds through it.