Shooting a S&W 500 FAIL

[skosh69]

She lucky she didn't hurt herself. I've shot these before, it's not for the timid or weak.

[Caleb]

Wow....

[dw1911]

Ouch is right! Poor Woman. Those guns are not for the weaker to shoot. They pack one Heck of a recoil! I have shot one a few times! RECOIL!

[sdmc530]

Originally Posted by IamCaleb

Wow....

said it there buddy.

[brownie]

Check the force applied to the wrist and elbow.

Gotta roll with these big guys, not try to fight the force as she did. I leave them alone when asked to shoot them myself.

[DrHenley]

I've had a little experience with big kickers. I developed a technique with my 454 Casull that allows the force to be dissipated without getting hit in the head with the pistol. Of course that's an Encore pistol that is not really suitable for a conventional hold. With the Encore pistol, the 12" barrel, with no cylinder gap, develops significantly more recoil than a 10" revolver.

I was at the range shooting it and a guy with a 500 S&W was there at the same time, and we shot each other's pistols and compared notes. Both were about equally painful...

I taught my daughter to shoot the Casull, starting with a light load, then a medium load (equivalent to a 44 mag max load) to get the technique down and then went to a max load. Notice the right elbow is bent to allow the arm to flex at the elbow. She is pushing forward with the right hand and pulling back with the left, preloading the force applied by the right arm to keep the gun from flying straight back. This allows the upper arm to remain stationary while the forarm bends up with the recoil, allowing the gun to travel safely backwards and upwards.

[zukinut]

Originally Posted by DrHenley

I've had a little experience with big kickers. I developed a technique with my 454 Casull that allows the force to be dissipated without getting hit in the head with the pistol. Of course that's an Encore pistol that is not really suitable for a conventional hold. With the Encore pistol, the 12" barrel, with no cylinder gap, develops significantly more recoil than a 10" revolver.

I was at the range shooting it and a guy with a 500 S&W was there at the same time, and we shot each other's pistols and compared notes. Both were about equally painful...

I taught my daughter to shoot the Casull, starting with a light load, then a medium load (equivalent to a 44 mag max load) to get the technique down and then went to a max load. Notice the right elbow is bent to allow the arm to flex at the elbow. She is pushing forward with the right hand and pulling back with the left, preloading the force applied by the right arm to keep the gun from flying straight back. This allows the upper arm to remain stationary while the forarm bends up with the recoil, allowing the gun to travel safely backwards and upwards.

That was a big ol great smile on her face

[zukinut]

I like shooting the bigger bore wheel guns when I have the chance. My buddy has a 44 mag I like shooting off at steel plates. You have to have some strength and technique to do it. Not just giving someone who doesn't have a clue something like that always seems to end badly.

[brownie]

Also, notice the gas escaping from the muzzle, but it appears the gases aren't escaping through/at the forcing cone but the rear of the cylinder and possibly through the hammer. I don't see any flash where I expected it to be.

[Xbonz]

Originally Posted by brownie

Also, notice the gas escaping from the muzzle, but it appears the gases aren't escaping through/at the forcing cone but the rear of the cylinder and possibly through the hammer. I don't see any flash where I expected it to be.

To what do you attribute those issues?