|
|
| Register | Forums | Blogs | Today's Posts | Search | Donate |
 |
 |
 |
|
|
|
#1
02-09-2012, 08:14 PM
|
|||||
|
|||||
Quote:
http://www.cotep.org/forum/showthread.php?t=566 
|
|
#2
02-09-2012, 09:33 PM
|
|||||
|
|||||
|
I think the slide being hard to pull back this the key.
I did get a bad batch of bullets, They did hit the lands of the rifling. The slide stopped about 1/8" of going into full battery. Some I could push the slide forward and others I'd have to pull so hard that the casing flew out, the powder all over the floor and the bullet dropped out of the mag well.  After that I had Extractor problems...... all caused by me. I guess I'm out of suggestions. Sorry.  Greg
__________________
If it wasn't for an electrician, you'd be watching TV in the dark.  Author Unknown CBOB:0581
|
|
#3
02-08-2012, 06:39 PM
|
|||||
|
|||||
|
Lube it very well with a heavier viscosity oil like FP 10 rack slide 200 times. See if that solves the problem. Run it very wet. The tight tolerances sound like the problem.
__________________
canis fidelis cave canem, vereor non magnus nocens lupus In hoc signo vinces If you can list them, you ain't got enough!!! Life Member NRA, SCI, ATA, NSCA COTEP 414
|
|
#4
02-08-2012, 06:41 PM
|
|||||
|
|||||
|
But i am running it very wet with , with FP10...Have done so from the start
In fact, every time i am done shooting, i need to wipe it clean because when it warms, the fp10 come out the sides. Just took the slide off, it's still wet, that's how i put it away after shooting: pic doesn't do it justice, that's pretty wet 
__________________
Stijn Vandamme 08 Dan Wesson PM7-45 < > COTEP PM70562 Ypres , Belgium , Euh-rop Last edited by svandamme; 02-08-2012 at 07:10 PM.
|
|
#5
02-08-2012, 06:57 PM
|
|||||
|
|||||
|
Sorry Terry I guess I missed the part that it happened with factory ammo too.
__________________
CBOB0405 ︻┳═一 “When you get to the end of your rope, tie a knot and hold on. Help is on the way.” Author Unknown
|
Hybrid Mode