COTEP.org  

Go Back   COTEP.org > Main Category > COTEP University

Reply
 
Thread Tools Display Modes
  #1  
Old 12-10-2013, 01:34 PM
Dave Waits's Avatar
Dave Waits Dave Waits is offline
Founding COTEP Member who is watching over us from above with God at a giant shooting range in heaven
COTEP Member
 
Join Date: Apr 2011
Location: Loveland, Ohio
Posts: 928
Thanks: 4
Thanked 229 Times in 59 Posts
Default Tightening a Gas-Cylinder the AFPG-way

One of the biggest accuracy-killers on a M1 Garand is a loose Gas-Cylinder. The front sight is mounted on top of the Cylinder and, if the Gas-Cylinder is loose the front sight moves around every time the rifle is fired. I don't need to tell anybody here what that will do to groupsize. I've seen fliers at 200 yards that were six-inches away from the main group due to this.

There are two ways to correct this, three if you count a new Gas-Cylinder. However, an unissued Gas-Cylinder will run you about $125.00. So, we'll concentrate on the first two. Both methods involve tightening the barrel channels the Gas-Cylinder slides into.

Picture of Gas-Cylinder slot-channels;


The first uses a 1/2",3/8ths.drive socket, a Hammer, the barrel and a hard surface. You merely lay the socket in the slot and lightly tap it with the Hammer. You do this to all three slots and try the fit. Ideally, you want to be tight enough to require driving the Gas-Cylinder on with a plastic mallet. The tighter the better but, you don't want to batter or damage the slots. You just want to move enough metal into the slot to tighten the fit.

The problem with this type of tightening is that you can only do it once or twice before the slots are peened to the point of uselessness.

The Second method is by far the best. You need a small hammer, a hard surface, a 1/8th" centerpunch and, of course, the barrel. What you are going to do is put a dimple alongside the slot,front and back, about 1/16th." in from the edge on each side of all three slots. Be sure you center the barrel port in the Gas-Cylinder port before doing this so you can scribe a light mark on the backside of the barrel pad for reference. You only need to use light strikes on the punch to move enough metal to get a good tight fit. See below.


This is how they tightened Gas-Cylinders on the Air Force Premium-Grade M1 Match rifles. If the Gas-Cylinder loosens after several cleaning all that is required is to strike the dimples again with the center punch causing far less damage to the barrel.

Hope this helps
__________________
Diligentia, Vis, Celeritas
COTEP#CBOB0428
NRA,GCA,OGCA, USAF,Msgt.(Ret.)
Reply With Quote
The Following 5 Users Say Thank You to Dave Waits For This Useful Post:
BlackKnight (12-13-2013), Caleb (12-10-2013), jmlutz (12-10-2013), Riverpigusmc (12-10-2013), ronpaul50 (12-10-2013)
  #2  
Old 12-13-2013, 08:33 PM
Caleb's Avatar
Caleb Caleb is offline
COTEP Member
 
Join Date: Sep 2013
Location: Earth
Posts: 11,463
Thanks: 4,192
Thanked 1,137 Times in 254 Posts
Default

Great information, thank you..
__________________
**I have been Enlightened**
Reply With Quote
Reply




All times are GMT -4. The time now is 07:24 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.