Aftermarket back plates..

Pirate · #1 01-04-2018, 10:16 PM

I replaced the extractor as it was worn. Only had one issue so it could have been me. The springs seem fine as I don't think I even have 2k rounds through it.

sdmc530 · #2 01-04-2018, 10:32 PM

Quote:

Originally Posted by Pirate

I replaced the extractor as it was worn. Only had one issue so it could have been me. The springs seem fine as I don't think I even have 2k rounds through it.

2k is nothing so run it and see if it’s fixed. Weird that the extractor was bad that fast though. Might have had a bad one?

pitor · #3 01-07-2018, 10:42 AM

Quote:

Originally Posted by sdmc530

2k is nothing so run it and see if it’s fixed. Weird that the extractor was bad that fast though. Might have had a bad one?

This, the extractor should be good for a couple of Thousand rounds minimum, unless you're shooting a lot of Steel case ammo, in which case it does beat up the extractor pretty badly needing replacement sooner than later.