Any advice on a 458 SOCOM upper?

[DrHenley]

I have a question for you AR gurus.
I have a milspec buttstock with the fixed sling swivel and a webbing slot.
How can I put a QD mount on there? Is there one that can replace the fixed sling swivel or that attaches to the webbing slot?

[BlackKnight]

Originally Posted by DrHenley

I have a question for you AR gurus.
I have a milspec buttstock with the fixed sling swivel and a webbing slot.
How can I put a QD mount on there? Is there one that can replace the fixed sling swivel or that attaches to the webbing slot?

Good question. I don't use QD mounts on the buttstock only on the foregrip.
Here's what I found. Hope this helps.
https://midwestindustriesinc.com/qui...-car-m4-stock/
https://midwestindustriesinc.com/qd-...ion-car-stock/
I've used Midwest Industries products in the past. They're good quality.

[DrHenley]

Thanks!

I think for now I'm going to just use the QD for the front, using an M-LOK QD swivel, and clip onto the stock sling swivel on the buttstock, and worry about the rear QD swivel later.

I ordered this sling from Amazon:

[Horse'nround]

So I would assume you are looking for the sling plate that goes under the buffer tube nut.
https://bravocompanyusa.com/bcmgunfighter-qd-end-plate/

https://phase5wsi.com/sloped-quick-d...te-sqd-ep.html

Left / Right 2 point

https://www.amazon.com/Lytoybe-Adapt...4793480&sr=8-4

[Horse'nround]

So I've been playing with a few types for a while now. My BIL Mr.3 gun was having some issues with slinging and setup too. Some buds in TAC CQB squad turned me on to these; VTAC 2 point quick release. One pull draw and release to set and one pull deploy. Pretty nifty rig and easy to setup.

https://www.vikingtactics.com/category-s/1833.htm

[BlackKnight]

Originally Posted by Horse'nround

So I've been playing with a few types for a while now. My BIL Mr.3 gun was having some issues with slinging and setup too. Some buds in TAC CQB squad turned me on to these; VTAC 2 point quick release. One pull draw and release to set and one pull deploy. Pretty nifty rig and easy to setup.

https://www.vikingtactics.com/category-s/1833.htm

Very good sling and company. They were the innovators of two point slings.
I'm a big fan of Magpul slings. I have MS1's on my rifles.
https://magpul.com/firearm-accessori...gs/slings.html

https://i.imgur.com/I68Mvi2.jpg
https://i.imgur.com/kSb0bvv.jpg

[DrHenley]

I'd like to keep it simple. Ideally, I'd just install a QD receiver in a port made for it, like many stocks have (but mine doesn't) but since it doesn't, I like something on the order of a QD receiver that either attaches to the webbing slot or replaces the fixed sling swivel. Attaching it to the buffer tube or receiver doesn't work for me. Too far forward. (butt would stick up too far making it difficult to climb into deer stands)

[DrHenley]

If I could just wave my magic wand, I could make one of these appear on my stock. But unfortunately my magic wand is broken.

[Horse'nround]

I understand.
I moved to the tube ring as it is a fixed point on the rifle and doesn't affect the sitting point when slung. Using the stock inherently gives you a moving reference. Besides my stubby AR's have folding stocks...