COTEP.org  

Go Back   COTEP.org > Main Category > The Dremel Room

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #8  
Old 10-07-2011, 12:49 PM
svandamme's Avatar
svandamme svandamme is offline
Founding Member
COTEP Member
 
Join Date: Sep 2011
Location: Belgium , In Flanders Fields where the poppies blow
Posts: 112
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Fair enough, it's not about spending money for me.. I have the moly kote laying around my garage anyway.. The stuff is very durable.. tore down an 911 RS spec engine that was used for rallying... The darn thing had been driven hard for break in.. Normally bearings would be showing wear after 5000 km's.. not so.. the molykote was still on there.

I'm not worried bout dust or grease, i clean the thing to often (it's still new )

It's more that i don't like seeing it sweat it's lubricant on the rail...looks messy.
so if the molykote can reduce the requirements for lube in that area.. i'm all for it. Not eliminate, jus reduced..
__________________
Stijn Vandamme
08 Dan Wesson PM7-45 < > COTEP PM70562
Ypres , Belgium , Euh-rop
Reply With Quote
 




All times are GMT -4. The time now is 08:17 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.